Cranes - Loader cranes

This document specifies minimum requirements for design, calculation, examinations and tests of hydraulic powered loader cranes and their mountings on vehicles or static foundations.
This document applies to loader cranes designed to be installed on:
-   road vehicles, including trailers, with load carrying capability;
-   tractors (road or agricultural), where only a towed trailer has capability to carry goods;
-   demountable bodies to be carried by any of the above;
-   other types of carriers (e.g. separate loaders, crawlers, rail vehicles, non-seagoing vessels);
-   static foundations.
This document also applies to loader cranes equipped with special tools or interchangeable equipment (e.g. grapple, clamshell bucket, pallet clamp, etc.), as specified in the operator’s manual.
This document does not apply to loader cranes used on board sea going vessels or to articulated boom system cranes which are designed as total integral parts of special equipment such as forwarders.
The hazards covered by this document are identified in Clause 4.
This document does not cover hazards related to the lifting of persons.
NOTE   The use of cranes for lifting of persons can be subject to specific national regulations.
This document is not applicable to loader cranes manufactured before the publication of this document. For loader cranes designed before the publication of this document, the provisions concerning stress calculations in the version of EN 12999 that was valid at the time of their design, are still applicable.

Krane - Ladekrane

Dieses Dokument legt Mindestanforderungen an Gestaltung, Berechnung, Untersuchungen und Prüfungen von hydraulisch angetriebenen Ladekranen und deren Montage auf Fahrzeuge oder ortsfeste Unter¬konstruktionen fest.
Dieses Dokument gilt für Ladekrane, die dafür vorgesehen sind, wie folgt montiert zu werden:
- auf Straßenfahrzeuge, einschließlich Anhängern, mit einer verbleibenden Nutzlast;
- auf Traktoren (Straße oder Landwirtschaft), bei denen nur der Anhänger über die Möglichkeit verfügt, Güter zu befördern;
- als demontierbare Einrichtungen, die von einer der oben genannten Maschinen mitgeführt werden;
- auf sonstigen Trägerarten (z. B. Separat-Lader, Raupenfahrzeuge, Schienenfahrzeuge, nicht hochseetüchtige Schiffe);
- auf ortsfeste Unterkonstruktionen.
Dieses Dokument gilt außerdem für Ladekrane, die mit Spezialwerkzeugen oder austauschbaren Ausrüstungsteilen (z. B. Greifer/Zange, Zweischalengreifer, Palettengabel usw.), wie in der Betriebsanleitung festgelegt, ausgestattet sind.
Dieses Dokument gilt nicht für Ladekrane auf Seeschiffen sowie Krane mit Knickauslegersystem, die vollständig als integraler Bestandteil einer speziellen Ausrüstung, wie z. B. Rückefahrzeug (Forwarder), ausgelegt sind.
Die Gefährdungen, die in diesem Dokument behandelt werden, sind in Abschnitt 4 aufgeführt.
Dieses Dokument behandelt nicht die Gefährdungen, die beim Heben von Personen auftreten.
ANMERKUNG Die Verwendung von Kranen für das Heben von Personen kann besonderen nationalen Vorschriften unterliegen.
Dieses Dokument gilt nicht für Ladekrane, die vor dem Datum der Veröffentlichung dieses Dokuments hergestellt wurden. Für Ladekrane, die vor Veröffentlichung dieses Dokuments konstruiert wurden, gelten nach wie vor die Festlegungen hinsichtlich der Spannungsberechnungen entsprechend der Ausgabe von EN 12999, die zum Zeitpunkt ihrer Konstruktion gültig war.

Appareils de levage à charge suspendue - Grues de chargement

Le présent document spécifie les prescriptions minimales relatives à la conception, au calcul, aux examens et aux essais des grues de chargement hydrauliques et à leur montage sur des véhicules ou massifs pour montage à poste fixe.
Le présent document s'applique aux grues de chargement conçues pour être installées sur :
-   des véhicules routiers, y compris les remorques, ayant une capacité de charge ;
-   des tracteurs (routiers ou agricoles), lorsque seule la remorque tractée est capable de transporter des marchandises ;
-   des caisses amovibles qui doivent être transportées par l'un des véhicules susmentionnés ;
-   d'autres types de transporteurs (par exemple : chargeurs séparés, transporteurs sur chenilles, transporteurs sur rail, navires d’eau douce) ;
-   des bases statiques.
Le présent document s'applique également aux grues de chargement équipées d'outils spéciaux ou d'équipements interchangeables (par exemple, grappin, benne preneuse, pince à palette, etc.), comme indiqué dans le manuel de l'opérateur.
Le présent document ne s'applique pas aux grues de chargement utilisées à bord des navires de haute mer et aux appareils de levage à charge suspendue à flèche articulée qui sont conçus comme faisant partie intégrante d’un équipement spécial tel que des débardeuses.
Les phénomènes dangereux couverts par le présent document sont identifiés à l’Article 4.
Le présent document ne couvre pas les phénomènes dangereux relatifs au levage de personnes.
NOTE   L’utilisation d’appareils de levage pour le levage de personnes peut être soumise à des réglementations nationales spécifiques.
Le présent document ne s'applique pas aux grues de chargement construites avant sa publication. Pour les grues de chargement conçues avant la publication du présent document, les dispositions concernant les calculs de contraintes dans la version de l’EN 12999 qui était valable au moment de leur conception, ne sont pas encore applicables.

Žerjavi - Nakladalni žerjavi

General Information

Status
Published
Publication Date
13-Oct-2020
Withdrawal Date
29-Apr-2021
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
14-Oct-2020
Due Date
06-Nov-2020
Completion Date
14-Oct-2020

Relations

Effective Date
23-Aug-2017
Effective Date
08-Jun-2022

Buy Standard

Standard
EN 12999:2020 - BARVE
English language
107 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
prEN 12999:2019
English language
103 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 12999:2020
01-december-2020
Nadomešča:
SIST EN 12999:2011+A2:2018
Žerjavi - Nakladalni žerjavi
Cranes - Loader cranes
Krane - Ladekrane
Appareils de levage à charge suspendue - Grues de chargement
Ta slovenski standard je istoveten z: EN 12999:2020
ICS:
53.020.20 Dvigala Cranes
SIST EN 12999:2020 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 12999:2020

---------------------- Page: 2 ----------------------
SIST EN 12999:2020


EN 12999
EUROPEAN STANDARD

NORME EUROPÉENNE

October 2020
EUROPÄISCHE NORM
ICS 53.020.20 Supersedes EN 12999:2011+A2:2018
English Version

Cranes - Loader cranes
Appareils de levage à charge suspendue - Grues de Krane - Ladekrane
chargement
This European Standard was approved by CEN on 10 August 2020.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 12999:2020 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN 12999:2020
EN 12999:2020 (E)
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms, definitions, illustration of parts and abbreviated terms . 8
3.1 Terms and definitions . 8
3.2 Illustration of parts . 13
3.3 Abbreviated terms . 15
4 List of significant hazards . 15
5 Safety requirements and/or protective/risk reduction measures . 18
5.1 General . 18
5.2 Structural calculation . 18
5.3 Stress analysis . 24
5.4 Mechanical arrangements. 25
5.5 Hydraulic system . 27
5.6 Limiting and indicating devices . 29
5.7 Controls .
...

SLOVENSKI STANDARD
oSIST prEN 12999:2019
01-maj-2019
Žerjavi - Nakladalni žerjavi
Cranes - Loader cranes
Krane - Ladekrane
Appareils de levage à charge suspendue - Grues de chargement
Ta slovenski standard je istoveten z: prEN 12999
ICS:
53.020.20 Dvigala Cranes
oSIST prEN 12999:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 12999:2019

---------------------- Page: 2 ----------------------
oSIST prEN 12999:2019


DRAFT
EUROPEAN STANDARD
prEN 12999
NORME EUROPÉENNE

EUROPÄISCHE NORM

March 2019
ICS 53.020.20 Will supersede EN 12999:2011+A2:2018
English Version

Cranes - Loader cranes
Appareils de levage à charge suspendue - Grues de Krane - Ladekrane
chargement
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 147.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12999:2019 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 12999:2019
prEN 12999:2019 (E)
Contents Page
European foreword . 5
Introduction . 6
1 Scope . 7
2 Normative references . 7
3 Terms, definitions, illustration of parts and abbreviated terms . 9
3.1 Terms and definitions . 9
3.2 Illustration of parts . 14
3.3 Abbreviated terms . 16
4 List of significant hazards . 16
5 Safety requirements and/or safety measures . 19
5.1 General . 19
5.2 Structural calculation . 19
5.2.1 Information to be given in the calculation . 19
5.2.2 Dynamic factors . 20
5.2.3 L
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.