Evaluation and routine testing in medical imaging departments - Part 3-6: Acceptance and constancy tests - Imaging performance of mammographic X-ray equipment used in a mammographic tomosynthesis mode of operation

IEC 61223-3-6:2020 applies to the performance of MAMMOGRAPHIC X-RAY EQUIPMENT when used in MAMMOGRAPHIC TOMOSYNTHESIS modes of operation, with respect to image quality and dose. Excluded from the scope of this document are: - MAMMOGRAPHIC X-RAY EQUIPMENT modes of operation other than MAMMOGRAPHIC TOMOSYNTHESIS; - 2D images synthesised from the tomosynthesis images; - reconstructive TOMOGRAPHY other than MAMMOGRAPHIC TOMOSYNTHESIS; - CT SCANNERS covered by IEC 61223-3-5. IEC 61223-3-6:2020 defines a) the essential parameters which describe the acceptability criteria of MAMMOGRAPHIC TOMOSYNTHESIS modes of operation of MAMMOGRAPHIC X-RAY EQUIPMENT with regard to image quality and dose, b) the methods of testing whether measured quantities related to those parameters comply with specified tolerances, and c) CONSTANCY TEST frequency when required. This document is intended to be applied along with the acceptability criteria included in IEC 61223-3-2 or equivalent protocol for 2D mammography which are also relevant for MAMMOGRAPHIC TOMOSYNTHESIS modes of operation. These methods mainly rely on non-invasive measurements that use appropriate test equipment and are performed during or after the installation. Signed statements covering steps in the installation procedure can be used as part of the ACCEPTANCE TEST. Tests required by a higher level of compliance take precedence over similar tests with a lower level of compliance. When the results of the ACCEPTANCE TEST are in compliance with the expected values, the BASELINE VALUES for the subsequent CONSTANCY TESTS are established.

Bewertung und routinemäßige Prüfung in Abteilungen für medizinische Bildgebung - Teil 3-6: Abnahmeprüfungen und Konstanzprüfungen – Leistungsmerkmale zur Bildgebung im mammographischen Tomosynthese-Betrieb von Röntgen-Mammographiegeräten

Essais d'évaluation et de routine dans les services d'imagerie médicale - Partie 3-6: Essais d'acceptation et de constance - Performance d'imagerie des appareils de mammographie à rayonnement X utilisés en mode tomosynthèse en mammographie

L'IEC 61223-3-6:2020 s'applique aux performances des APPAREILS DE MAMMOGRAPHIE A RAYONNEMENT X utilisés en mode TOMOSYNTHESE EN MAMMOGRAPHIE, en matière de qualité d'image et de dose. Sont exclus du domaine d'application du présent document: - les modes de fonctionnement des APPAREILS DE MAMMOGRAPHIE A RAYONNEMENT X autres que la TOMOSYNTHESE EN MAMMOGRAPHIE; - les images 2D synthétisées à partir d'images de tomosynthèse; - la TOMOGRAPHIE reconstructrice autre que la TOMOSYNTHESE EN MAMMOGRAPHIE; - les TOMODENSITOMETRES couverts par l'IEC 61223-3-5. L'IEC 61223-3-6:2020 définit: a) les paramètres essentiels qui décrivent les critères d'acceptabilité des modes TOMOSYNTHESE EN MAMMOGRAPHIE des APPAREILS DE MAMMOGRAPHIE A RAYONNEMENT X en matière de qualité d'image et de dose; b) les méthodes d'essai visant à déterminer si les grandeurs mesurées liées à ces paramètres sont conformes aux tolérances spécifiées; et c) la fréquence d'ESSAI DE CONSTANCE, le cas échéant. Le présent document est destiné à s'appliquer avec les critères d'acceptabilité inclus dans l'IEC 61223-3-2 ou un protocole de mammographie 2D équivalent, lesquels s'appliquent également aux modes TOMOSYNTHESE EN MAMMOGRAPHIE. Ces méthodes reposent principalement sur des mesures non invasives, exécutées pendant ou après l'installation, en utilisant des équipements d'essai appropriés. Des déclarations signées couvrant des étapes de la procédure d'installation peuvent être utilisées dans le cadre de l'ESSAI D'ACCEPTATION. Les essais exigés par un niveau de conformité plus élevé prévalent sur les essais similaires associés à un niveau de conformité plus faible. Lorsque les résultats de l'ESSAI D'ACCEPTATION sont conformes aux valeurs attendues, les VALEURS DE BASE des ESSAIS DE CONSTANCE ultérieurs sont établies.

Ovrednotenje in kosovno preskušanje v medicinskih oddelkih za slikanje - 3-6. del: Preskusi sprejemljivosti in konstantnosti - Slikovni učinek mamografske rentgenske opreme, ki se uporablja v mamografskem načinu delovanja tomosinteze (IEC 61223-3-6:2020)

General Information

Status
Published
Publication Date
02-Apr-2020
Current Stage
6060 - Document made available - Publishing
Start Date
03-Apr-2020
Completion Date
03-Apr-2020

Buy Standard

Standard
EN IEC 61223-3-6:2020 - BARVE
English language
56 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN IEC 61223-3-6:2020
01-julij-2020
Ovrednotenje in kosovno preskušanje v medicinskih oddelkih za slikanje - 3-6. del:
Preskusi sprejemljivosti in konstantnosti - Slikovni učinek mamografske
rentgenske opreme, ki se uporablja v mamografskem načinu delovanja
tomosinteze (IEC 61223-3-6:2020)
Evaluation and routine testing in medical imaging departments - Part 3-6: Acceptance
and constancy tests - Imaging performance of mammographic X-ray equipment used in
a mammographic tomosynthesis mode of operation (IEC 61223-3-6:2020)
Bewertung und routinemäßige Prüfung in Abteilungen für medizinische Bildgebung - Teil
3-6: Abnahmeprüfungen und Konstanzprüfungen – Leistungsmerkmale zur Bildgebung
im mammographischen Tomosynthese-Betrieb von Röntgen-Mammographiegeräten
(IEC 61223-3-6:2020)
Essais d'évaluation et de routine dans les services d'imagerie médicale - Partie 3-6:
Essais d'acceptation et de constance - Performance d'imagerie des appareils de
mammographie à rayonnement X utilisés en mode tomosynthèse en mammographie
(IEC 61223-3-6:2020)
Ta slovenski standard je istoveten z: EN IEC 61223-3-6:2020
ICS:
11.040.50 Radiografska oprema Radiographic equipment
SIST EN IEC 61223-3-6:2020 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN IEC 61223-3-6:2020

---------------------- Page: 2 ----------------------
SIST EN IEC 61223-3-6:2020


EUROPEAN STANDARD EN IEC 61223-3-6

NORME EUROPÉENNE

EUROPÄISCHE NORM
April 2020
ICS 11.040.50

English Version
Evaluation and routine testing in medical imaging departments -
Part 3-6: Acceptance and constancy tests - Imaging
performance of mammographic X-ray equipment used in a
mammographic tomosynthesis mode of operation
(IEC 61223-3-6:2020)
Essais d'évaluation et de routine dans les services Bewertung und routinemäßige Prüfung in Abteilungen für
d'imagerie médicale - Partie 3-6: Essais d'acceptation et de medizinische Bildgebung - Teil 3-6: Abnahmeprüfungen und
constance - Performance d'imagerie des appareils de Konstanzprüfungen – Leistungsmerkmale zur Bildgebung
mammographie à rayonnement X utilisés en mode im mammographischen Tomosynthese-Betrieb von
tomosynthèse en mammographie Röntgen-Mammographiegeräten
(IEC 61223-3-6:2020) (IEC 61223-3-6:2020)
This European Standard was approved by CENELEC on 2020-03-13. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.


European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN IEC 61223-3-6:2020 E

---------------------- Page: 3 ----------------------
SIST EN IEC 61223-3-6:2020
EN IEC 61223-3-6:2020 (E)
European foreword
The text of document 62B/1127/CDV, future edition 1 of IEC 61223-3-6, prepared by SC 62B
"Diagnostic imaging equipment" of IEC/TC 62 "Electrical equipment in medical practice" was
submitted to the IEC-CENELEC parallel vote and approved by CENELEC as EN IEC 61223-3-6:2020.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2020-12-13
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2023-03-13
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Endorsement notice
The text of the International Standard IEC 61223-3-6:2020 was approved by CENELEC as a
Eur
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.